Georgetown, Texas
Back to Blog

Garbage Disposal Replacement in Georgetown: What It Takes

The serial number on the housing tells you how old the unit is. Whether the mounting assembly under your sink gets reused tells you how long the swap takes.

Garbage DisposalsPublished November 18, 2026Vaquero Plumbing, RMP 15304

Replacing a garbage disposal in Georgetown is a one-visit job on most kitchens, and what decides how long it takes is whether the mounting assembly already under your sink gets reused. Before you buy anything, two questions settle whether you need a new unit at all: how old the one you have is, and whether the disposal is actually what is wrong. Here is how we work that out, and what the swap involves once it is decided, under licence RMP 15304.

First, find out how old it is

The age of your disposal is printed on the unit and almost nobody looks. InSinkErator puts the serial number on a gray tag near the bottom of the housing, and the number itself carries the build date: the first two digits are the year of manufacture and the second two are the month. A unit stamped 1503 was built in March 2015. Units made from summer 2024 use a newer 10-digit format mixing numbers and letters.

That number also tells you whether anyone else is paying. InSinkErator starts the warranty period from the later of the install date, the purchase date or the manufacture date on that tag, so a unit still inside its term is worth a call to the manufacturer first. Our own garbage disposal repair and installation page names a disposal over a decade old that keeps needing attention as the point where replacing it stops being the expensive choice.

Get the tag read before you shop. A disposal under warranty and a disposal fifteen years old are two different conversations, and the serial number is the only thing that tells them apart.

Make sure the disposal is the actual problem

A sink that fills up while the disposal grinds normally is a drain problem, not a disposal problem. InSinkErator publishes a test for this that takes ten seconds: run the unit and look at the water. A whirlpool means the drain line downstream is restricted, and a new disposal bolted onto that same restricted line behaves exactly like the old one.

Humming, silence and leaks each point somewhere specific too, and we wrote those up separately in what a humming, silent or leaking disposal is telling you. Work through that first. One rule applies no matter which symptom you have: InSinkErator is explicit that you do not put your hand in the disposal at any time.

What a replacement actually involves

InSinkErator's own replacement procedure runs 13 numbered steps, and the first one is electrical: power off at the fuse box or circuit breaker before anything is loosened. The drain trap comes off the waste discharge tube, then the old unit is freed from the lower mounting ring and lowered out. Laid on its side, its cover plate comes off and the wiring is disconnected at the connectors and the ground screw.

Then comes the fork in the job. If the existing mounting hardware is sound, the manufacturer's instruction is to leave it alone and skip ahead to hanging the new unit. If it is not, the three mounting screws come out, the snap ring is pried off, the old sink flange is pushed up through the sink hole and the old putty is scraped off the rim. The new flange is bedded in a 1/2 inch rope of plumber's putty.

PartReused or newWhat decides it
Mounting assembly and sink flangeOften reusedWhether the old hardware is sound and matches the new unit
Plumber’s putty at the sink rimNewAlways new if the flange comes out
Discharge tubeNew with the unitCut shorter if too long, extended if too short
Dishwasher knockout plugTapped outOnly if a dishwasher drains into the unit
Electrical connectionReusedHardwired stays hardwired; a cord on a hardwired unit needs a cord kit
Trap and branch drainReusedReplaced only if the drain is the real complaint

The last step is the one worth asking about. The manufacturer has the finished job tested for leaks at four points, the sink flange, the dishwasher connection, the tail-pipe and the mounting assembly, and only then is the breaker switched back on. If nobody filled the bowl and watched those four places, the job is not finished.

The dishwasher step people miss

A new disposal ships with the dishwasher inlet sealed. InSinkErator says that if a dishwasher is being connected, the knockout plug has to be tapped out with a screwdriver and hammer, and that the loose plug then has to be removed from inside the unit. Skip the first half and the dishwasher cannot drain. Skip the second half and a disc of plastic is loose in the grind chamber waiting to jam it.

The manufacturer also notes the dishwasher drain hose may be connected through an air gap, clamped to the dishwasher inlet. Which arrangement your kitchen uses is a code question rather than a preference, which is where Georgetown comes in.

What Georgetown requires

Georgetown enforces the 2021 International Plumbing Code, adopted along with the 2021 International Residential, Mechanical and Fuel Gas Codes and effective November 1, 2023. Permits are applied for and paid through the city's My Government Online portal, and inspections are requested the same way, by 3 p.m. for the next available business day, though the city states it cannot guarantee next business day for every inspection booked by that cutoff.

Whether a particular swap needs a permit is the city's call, not ours. Georgetown asks residents to contact Development Services before applying if the requirements are unclear, and publishes permits@georgetowntexas.gov for that. When we do the work, pulling permits and requesting inspections is part of what the licence obliges us to do.

What a new unit will not fix

A disposal is not a grease appliance, and the state is blunter about this than most plumbers are. The Texas Commission on Environmental Quality's household guidance tells Texans not to use a garbage disposal or food grinder at all, because grinding food before rinsing it down the drain does not remove fats, oils and grease, it only makes the pieces smaller. TCEQ adds that even non-greasy food scraps can plug a home's sewer lines.

That is why a replacement sometimes changes nothing. TCEQ explains that grease poured down kitchen drains builds up inside sewer pipes, restricts the flow and can push untreated wastewater back into homes. For Georgetown-area homes on a septic system, the agency warns that grease reaching the tank and drain field can cause malfunctions and more frequent pump-outs.

The habits TCEQ recommends cost nothing: scrape scraps into the trash, wipe pots with dry paper towels before rinsing, keep a catch basket over the drain, and rinse dishes with cold water before loading the dishwasher, because hot water melts grease off the plates and into the pipes. InSinkErator agrees: moderate cold water while grinding, keep it running a few seconds after, and never pour grease or fat into the disposal.

Who you are hiring

Texas lets you do this yourself at your own house. Occupations Code 1301.051 says a property owner is not required to be licensed to perform plumbing in their own homestead. Anyone you pay is held to a different standard: section 1301.351 says a person other than a responsible master plumber may not engage in plumbing unless they hold the proper licence and their work is supervised and controlled by a licence holder, and that anyone advertising or offering plumbing must secure the services of a responsible master plumber.

The Texas State Board of Plumbing Examiners spells out what that designation carries: supervising and managing all plumbing work performed under contracts secured under the licence, whether the people doing it are employees or subcontractors, carrying at least $300,000 of general commercial liability insurance, obtaining the permits and requesting the inspections the local codes require, and making sure everyone on the job holds a current licence or registration. The board also requires service vehicles to display the company name and the RMP licence number, which is the one thing you can check from your driveway.

Vaquero Plumbing is family-owned, works under RMP 15304 and covers Georgetown along with Liberty Hill, Leander, Cedar Park, Round Rock and Austin. The office is open Monday to Friday 7:30 to 5:30, Saturday 8:00 to 4:30 and Sunday 8:00 to 3:00, our work is backed by a two-year warranty, and the number is 512-893-8705. If the serial number says the unit has had its run, that is a Georgetown plumber call and we take it.

Sources

  1. InSinkErator, Installing a Replacement Garbage Disposal, Warranty Information and Fixing a Clogged Garbage Disposal.
  2. City of Georgetown, Adopted Building Code and Building Permits and Inspections.
  3. Texas Commission on Environmental Quality, Reducing Fats, Oils, and Grease in Your Home or Apartment and Keeping Fats, Oils, and Grease out of the Sewer System.
  4. Texas State Board of Plumbing Examiners, Responsible Master Plumber.
  5. Texas Occupations Code, Chapter 1301, Plumbers, sections 1301.051 and 1301.351.

Questions Leander homeowners ask us

How old is my garbage disposal?

The build date is in the serial number. InSinkErator puts the serial number on a gray tag near the bottom of the housing, and says the first two digits are the year of manufacture and the second two the month, so a unit stamped 1503 was built in March 2015. Units made from summer 2024 use a newer 10-digit format that mixes numbers and letters. The same number sets the warranty clock: InSinkErator starts the warranty period from the later of the install date, the purchase date, or the manufacture date identified by the serial number.

Does a new garbage disposal need new mounting hardware?

Not always. InSinkErator's replacement instructions say to remove the existing mounting hardware only if hardware replacement is needed, and otherwise to skip ahead to hanging the new unit. If the old assembly does come out, the three mounting screws are removed, the snap ring is pried off, the sink flange is pushed up through the sink hole and the old putty is scraped off the rim, and the new flange is set in a 1/2 inch rope of plumber's putty.

Why will my dishwasher not drain after a new disposal was installed?

The dishwasher inlet on a new disposal is sealed from the factory. InSinkErator says that if a dishwasher is being connected, the knockout plug has to be tapped out with a screwdriver and hammer and the loose plug then removed from inside the unit. If the plug was never tapped out the dishwasher cannot drain, and if it was tapped out but left in the chamber it can jam the new unit.

Will a new garbage disposal stop my kitchen drain clogging?

No, if grease is the cause. The Texas Commission on Environmental Quality's household guidance tells Texans not to use a garbage disposal or food grinder at all, because grinding food before rinsing it down the drain does not remove fats, oils and grease, it only makes the pieces smaller, and even non-greasy food scraps can plug a home's sewer lines. TCEQ also warns that grease reaching a septic tank and drain field can cause malfunctions and more frequent pump-outs.

Does replacing a garbage disposal in Georgetown need a permit?

That is the City of Georgetown's call. Georgetown enforces the 2021 International Plumbing Code, adopted effective November 1, 2023, and asks residents to contact Development Services before submitting an application if the permitting requirements are unclear. Permits are applied for and inspections requested through the city's My Government Online portal. A Texas Responsible Master Plumber is required to obtain the necessary permits and request the inspections the applicable codes call for.

Do you replace garbage disposals outside Georgetown?

Yes. Vaquero Plumbing covers Georgetown, Liberty Hill, Leander, Cedar Park, Round Rock and Austin under licence RMP 15304. The office is open Monday to Friday 7:30 to 5:30, Saturday 8:00 to 4:30 and Sunday 8:00 to 3:00.

Need a Hand From a Pro?

Skip the DIY — call the experts.

From leaks and clogs to water heaters and repipes, our family-owned crew is ready with same-day service and honest pricing.